LYMPH-O-RAY Tubes™
Operating Instructions

Preliminary Comments

1) Please be SURE that you've read and that you understand your WAVEFORMER XL™ Frequency Instrument - Operating Instructions, before starting your EXPERIMENTAL Treatment Session below.

2) Please ELIMINATE Steps 1 - 6 in the Operating Steps below, once they are COMPLETED the FIRST Time, if your LYMPH-O-RAY Tubes™ are going to be used on a REGULAR basis.

3) Please pay SPECIAL attention to the RED NOTES, which follow Operating Steps 3, 5, 6 & 10 below.

4) Please place your 12 Volt Power Supply (dark gray metal cabinet) at LEAST 3 ft. away from your Body, during your EXPERIMENTAL Treatment Session.
NOTE: Your 12 Volt Power Supply emits a 60 Hz. Electromagnetic Field, which is a Frequency, that can ADVERSELY affect your Health, especially when you're SERIOUSLY ILL.

5) Please place your WAVEFORMER XL™ Frequency Instrument on either a Plastic or a Wood Table.

6) Please clean your LYMPH-O-RAY Tubes™, if they have Film/Haze on them, with an ammonia-based Glass Cleaner, when they have COOLED DOWN and are NOT being used.

7) Please pull on the Plug(s) and NOT the Cable, when you disconnect Cables connected to your LYMPH-O-RAY Tubes™, 12 Volt Power Supply, High Voltage Power Supply, and WAVEFORMER XL™ Frequency Instrument.

8) Please lift your Power Supply #1 (light gray plastic case), when moving it to another location, because sliding your Power Supply #1 could DISPLACE it's Rubber Feet.

9) Please lift out the Plastic Exhaust Grill from the Exhaust Grill Holder, which is mounted on the top at end of your Power Supply #1 (light gray plastic case) every other month. Now remove the thin Sponge Filter from the Exhaust Grill Holder, clean it with Water, and squeeze it dry. Then replace the Sponge Filter into the Exhaust Grill Holder and push the Plastic Exhaust Grill back into place.

10) Please DO NOT use your LYMPH-O-RAY Tubes™ CONTINUOUSLY for MORE than 30 minutes, because the Power Transistor and Ignition Coil in your Power Supply #1 (light gray plastic case) could OVERHEAT EXCESSIVELY and then BURNOUT!
NOTE: If you allow your Power Supply #1 (light gray plastic case) to COOL DOWN for 30 minutes, then you may use it again CONTINUOUSLY for another 30 minutes.

11a) If you're SERIOUSLY-ILL, please follow Step 11b below, instead of this Step. Otherwise, please do your EXPERIMENTAL Treatment Session once per day (morning or evening) for a TOTAL EXPERIMENTAL Treatment Time per Session of 10 mins. Perform your EXPERIMENTAL Treatments for 6 consecutive days, and then NONE on the 7th day. REPEAT the SAME Cycle for 2 MORE weeks and then DISCONTINUE for 1 week. If the DESIRED Results have NOT been achieved, during the 1 week break, then REPEAT your EXPERIMENTAL Treatments, and CONTINUE them until the DESIRED Results are achieved.
NOTE: If you're ABLE, you should INCREASE your TOTAL EXPERIMENTAL Treatment Time on the 2nd Week to 20 mins. and on the 3rd week to 30 mins.

11b) Please do your EXPERIMENTAL Treatment Session, once per day (morning or evening), if you're SERIOUSLY-ILL, starting out with 3 mins. per Frequency, and NOT EXCEEDING 30 minutes of TOTAL EXPERIMENTAL Treatment Time. Do your EXPERIMENTAL Treatment Session EVERY 3 days (i.e. - Day Nos. 1, 4, 7, 10, 13, 16, 19 & 22) and then DISCONTINUE for 7 days. If you have NOT achieved the DESIRED Results, during the 1 week BREAK, then REPEAT your EXPERIMENTAL Treatments, and CONTINUE them, until the DESIRED Results are ACHIEVED.
NOTE: If you're ABLE, you should INCREASE your TOTAL EXPERIMENTAL Treatment Time on the 2nd Week to 40 mins., on the 3rd week to 50 mins. and on the 4th week to 60 mins..

Your EXPERIMENTAL Treatment Sessions should ONLY be STOPPED TEMPORARILY, if UNDUE DISCOMFORT is experienced, during the Detoxification Process. If DETOXIFICATION does become TOO UNCOMFORTABLE or ANY ADVERSE Reactions occur, then please DISCONTINUE &/or MODIFY your EXPERIMENTAL Treatment Sessions, and if possible, please try to continue your EXPERIMENTAL Treatment Sessions. Please drink 8 oz. of Activated Charcoal Slurry 6-8 times/day to ADSORB DEAD Pathogens, plus TOXIC Organic &/or Inorganic Chemicals from your Body. Please see Final Comments below) also.

Operating Steps

NOTE: Please take a look at the Connection Diagram (CLICK HERE), before preceding with the following Steps. Substitute your LYMPH-O-RAY Tubes™ for the BIOENERAY TUBE™.

1) Plug your 12 Volt Power Supply (dark gray metal cabinet) into a HIGH-Quality Surge Suppressor Power Strip (i.e. - 600+ joules), thus ensuring PROTECTION of your Power Supply.
NOTE: Your WAVEFORMER XL™ Frequency Instrument should also be plugged into a HIGH Quality Surge Suppressor Power Strip (i.e. - 600+ joules) for the SAME reason.

2) Push the 2 - stacking-type Gold Banana Plugs (Red & Black), which are connected to one end of the 6 ft. Cable #2, that has 2 - stacking-type Banana Plugs connected to the other end, into the corresponding color (Red & Black) Banana Jacks on the Front Panel (left corner) of your Power Supply #2 (dark gray metal cabinet).

3) Push the 2 - stacking-type Gold Banana Plugs (Red & Black), which are connected to other end of the 6 ft. Cable #2 into the corresponding color (Red & Black) Banana Jacks on the Front Panel (right side) of your Power Supply #1 (light gray plastic case).
NOTE: DO NOT plug the stacking-type Gold Banana Plugs (Red & Black), which are connected to the 6 ft. Cable #2, that now has the 2 - stacking-type Gold Banana Plugs on the other end connected to the corresponding color Banana Jacks on the Front Panel of your Power Supply #2 (dark gray metal cabinet), into the Black and Red Banana Jacks on your WAVEFORMER XL™ Frequency Instrument, because the 12 Volts will BURN-OUT it's Output Transistors!!

4) Connect the BNC Plug, which is connected to one end of the 6 ft. Cable #1, which has the 2 - flexible Banana Plugs connected to the other end, to the BNC Jack on the Front Panel (left side) of your Power Supply #1 (light gray plastic case).
NOTE: Match the 2 - Slots on the BNC Plug with the 2 - Pins on the BNC Jack and push the BNC Plug 'IN' and then turn the BNC Plug clockwise 1/4 turn.

5) Push the flexible Black Banana Plug, which is connected to the other end of the the 6 ft. Cable #1 into the Black Banana Jack, which is on the left side at the bottom of the Front Panel of your WAVEFORMER XL™ Frequency Instrument. Then push the flexible Red Banana Plug into the Red Banana Jack, which is on the left side at the bottom of the Front Panel of your WAVEFORMER XL™ Frequency Instrument.
NOTE: DO NOT plug the flexible Banana Plugs (Red & Black), which are connected to the end of the 6 ft. Cable #1, which now has the BNC Plug connected on the other end to the BNC Jack on the Front Panel of your Power Supply #1 (light gray plastic case), into the Red & Black Banana Jacks on your Power Supply #2 (dark gray metal cabinet), because the 12 Volts will BURN-OUT Power Supply #1's Power Transistor!!

6) Push the 2 - Banana Plugs (Red & Black), which are connected to ends of the High Voltage Wires (thick & black), that have the other ends connected to the ends of your LYMPH-O-RAY Tubes™, FIRMLY into the corresponding color (Red & Black) Heavy Duty Banana Jacks, which are on the middle top of the Rear Panel of your Power Supply #1 (light gray plastic case).
NOTE: Your LYMPH-O-RAY Tubes™ must be connected to the Power Supply #1 (light gray plastic case), when operating your WAVEFORMER XL™ Frequency Instrument, because the SPECIAL High Voltage Coil in your Power Supply #1 (light gray plastic case) could BURN OUT!
Please do NOT PROBE around the Heavy-Duty Banana Jacks or the Exhaust Grill/Filter with a metal object (i.e. - screwdriver), when operating your WAVEFORMER XL™ Frequency Instrument, since you could receive a VERY SEVERE SHOCK!

7) Do Lymph Massage, that's similiar to Dry Skin Brushing, using your LYMPH-O-RAY Tubes™ like 2 small Brushes to brush or stroke the Skin from the Feet towards the Heart and then from the Head down towards the Heart.
NOTE: You can also hold onto your LYMPH-O-RAY Tubes™ like Hand Cylinder Electrodes, having the Red Tube in your Left Hand and the Black Tube in your Right Hand for 5-10 minutes and then having the Black Tube in your Left Hand and the Red Tube in your Right Hand for 5-10 minutes.

Or you can also use an Elastic Bandage to hold each of your LYMPH-O-RAY Tubes™ in place (side-to-side or front-to-back) across an Area (inflammed, swollen, cyst, polyp, tumor, ...), which NEEDS to be treated.

Please place your Power Supply #1 (light gray plastic case) within 2 ft. of your LYMPH-O-RAY Tubes™, but at LEAST 3 ft. away from your Power Supply #2 (dark gray metal cabinet) and 3 ft. away from your WAVEFORMER XL™ Frequency Instrument.

Your Power Supply #1 (light gray plastic case), which is connected to your LYMPH-O-RAY Tubes™, can be within 1-3 ft. of your Body, because an Electromagnetic Field at the SPECIFIC Frequency is also being radiated by the High Voltage Coil inside.

8) Turn the OUTPUT LEVEL Control + OFF/ON Switch on the WAVEFORMER XL™ Frequency Instrument SLIGHTLY clockwise, just past the snapping sound, to turn the Power "ON".

9) Follow the Steps in the WAVEFORMER XL™ Frequency Instrument - Operating Instructions for whichever following Tuning Method you prefer: Ia - TUNING Knob/Single Frequency Operation, Ib - TUNING Knob/Dual Frequency Operation, IIa - Keypad/Single Frequency Operation or IIa - Keypad/Dual Frequency Operation.
NOTE: Return to Step 10 of these Operating Instructions, when you have tuned to the SPECIFIC Frequency (see Frequency Chart). Repeat this Step for each SPECIFIC Frequency (see Frequency Chart) of your EXPERIMENTAL Treatment Session.

10) Rock the Power Switch on your Power Supply #2 (dark gray metal cabinet) to turn it's Power "ON".
NOTE: Please notice that the 2" Cooling Fan on the top of your Power Supply #1 (light gray plastic case) is running and that your LYMPH-O-RAY Tubes™ are NOT yet glowing. If your LYMPH-O-RAY Tubes™ are GLOWING and your WAVEFORMER XL™ Frequency Instrument's Amplitude Control Knob is set at '0', then you've got a PROBLEM with the Power Supply #1 (light gray plastic case) and it NEEDS to be serviced!

Do NOT touch the Power Transistor, which is mounted on the Heat Sink on the Rear Panel of your Power Supply #2 (dark gray metal cabinet), because it can get VERY HOT!!

11) Turn the OUTPUT LEVEL Control + OFF/ON Switch on your WAVEFORMER XL™ Frequency Instrument COMPLETELY Clockwise, allowing it to REMAIN at this Setting throughout your EXPERIMENTAL Treatment Session for OPTIMAL Results.
NOTE: You should notice that there is a Plasma Glow inside of your LYMPH-O-RAY Tubes™.

12) Please follow the Final Steps below, when you've COMPLETED your Experimental Treatment Session.

Final Steps

1) Rock the Power Switch on your Power Supply #2 (dark gray metal cabinet) again to turn it's Power "OFF".

2) Turn the OUTPUT LEVEL Control + OFF/ON Switch on the WAVEFORMER XL™ Frequency Instrument COMPLETELY counter-clockwise, just past the snapping sound, to turn the Power "OFF".

3) Rock the Power Switch on the Power Strip to turn the Power "OFF" COMPLETELY to your WAVEFORMER XL™ Frequency Instrument and your LYMPH-O-RAY Tubes™.

Final Comments

1) Drink One 8 oz. glass of PURE Water with a liquid or freeze-dryed refrigerated Probiotic Product daily to replenish the friendly Intestinal Bacteria.
NOTE: Probiotic Products are AVAILABLE from Health Food Store or an Internet Website.

2) Drink 6-8 Glasses of Activated Charcoal Slurry (1 tsp./8 oz. - pure water) daily to ADSORB the HIGHER-than-normal amounts of TOXINS, which are NOW in the Bloodstream.
NOTE: Activated Charcoal Powder is AVAILABLE from Tom Harrelson/TOTAL HEALTH Associates/P.O. Box 9872/Columbus, OH 43209-00872/614-237-8708.

3) Take a SUPERIOR Laxative & Colon Cleanser (i.e. - Dr. Schulze's Intestinal Formulas #1 & #2) daily also (use as directed) to move the Bowels and ADSORB the TOXINS from the Intestines.
NOTE: Dr. Schulze's Intestinal Formulas #1 & #2 are AVAILABLE from American Botanical Pharmacy/800-437-2362.

According to FDA Regulations, I must post the following:
1) Consult your Physician before use.
2) CAUTION - The LYMPH-O-RAY Tubes™ should NOT be used on anyone, who wears a Pacemaker &/or a Defibrillator.
3) CAUTION - The LYMPH-O-RAY Tubes™ should NOT be used on anyone, who is PREGNANT.

Revised 3/2/03