According to F.D.A. regulations, I must tell you that at NO time should the PHOTON BLAZE™ be used to replace PROPER Medical Treatment, or be considered as a Replacement for PROPER Physician Care and for ALL Medical Conditions consult your Physician FIRST, before using this Experimental Biophoton Device, unless, of course, you are a physician.

1. Your PHOTON BLAZE™ can radiate 1 or 2 SOLID DEEP RED Light Beams, that are powered by a 7.4 Volt rechargeable Battery, which is mounted inside of the case of your PHOTON BLAZE™. The SOLID DEEP RED Light Beam(s), shining from one or both of the lens on the front of your PHOTON BLAZE™ while holding the case vertically and/or horizontally, being used to "light paint" a LARGE affected Body Area (i.e. - Skin, Joints, Involved Muscles, Tumors, etc.).

2. Please follow these Steps CAREFULLY to ENSURE EFFICIENT Operation of and EFFICACIOUS Results from your PHOTON BLAZE™.

1. Push the middle knurled button on the left side of the case of your PHOTON BLAZE™ from the right position to the left position, and allow the rechargeable battery to be locked into it's proper position, after you have released this knurled button.
NOTE: The metal tab, which is on the bottom of the rechargeable battery, needs to be pointed downwards, when pushing it into the channel on the rear of your PHOTON BLAZE™, so that the metal spring contact on it's case makes a SOLID connection with this metal tab.

2. Push the lower knurled button, which is on the left side of the case of your PHOTON BLAZE™ and slide it down from the upper 'OFF' position to the lower 'POWER' position to turn "ON" your PHOTON BLAZE™.
NOTE: If you want to power both Red LEDs, slide the top knurled button, which is on the left side of the case of your PHOTON BLAZE™ down from from the uppermost (single LED) position to the lower (dual LED) position.

3. Light paint" a LARGE (more than 3") affected Body Area (i.e. - Skin, Joints, Involved Muscles, Tumors, etc.) by tracing CLOCKWISE Circles with the SOLID DEEP RED Light Beam.
NOTE: When you're tracing these Circles, the Rate can be varied from SLOW to VERY RAPID. CHRONIC Condtions usually respond BEST to a RAPID Rate, whereas ACUTE Condtions usually respond BEST to a SLOWER Rate.
Please see the SPECIFIC Biophoton Light Therapy Treatment Instructions for the Frequency & Duration Of Treatments.

4. Perform this procedure on each area, which NEEDS to be treated, for 5-10 or more minutes.
NOTE: This Procedure can be done up to 3 times per day, and each area should receive a MAXIMUM Treatment Time per Day of 30 mins. (acute conditions) and 45 mins. (chronic conditions).
NOTE: The preceding treatment times and can be lengthened, if the desired results have not been obtained, treating for the above times.

5. When you've FINISHED, push the lower knurled button, which is on the left side of the case of your PHOTON BLAZE™ from the lower 'POWER' position to the upper 'OFF' position to turn "OFF" your PHOTON BLAZE™

1. Be SURE that your PHOTON BLAZE™ is completely turned "OFF".

2. Reverse the procedure in Step 1 of the Operating Steps above to remove the rechargeable battery from the rear of your PHOTON BLAZE™. Plug the wall style transformer power supply into an A.C. wall outlet and then insert this rechargeable battery.

3. Notice that the red LED on the rear of your PHOTON BLAZE™ is now "ON", indicating that the charging process has started.

4. The red color LED on the rear of your PHOTON BLAZE™ will change to a green color LED, when the charging process has been completed (3-4 hours).

5. Unplug the wall style transformer power supply from the A.C. wall outlet, shortly after the green color LED has appeared, thus ensuring LONGER life of the rechargeable battery.

1. Continue your EXPERIMENTAL Biophoton Light Therapy Treatments until you've obtained the DESIRED Results.

2. DISCONTINUE &/or MODIFY your EXPERIMENTAL Biophoton Light Therapy Treatments, using your PHOTON BLAZE™, if DETOXIFICATION becomes TOO UNCOMFORTABLE, but, then just as SOON as possible (1-2 days), please continue your EXPERIMENTAL Biophoton Light Therapy Treatment.

3. Monitor the duration of your EXPERIMENTAL Biophoton Light Therapy Treatments with a Digital Timer, while you're using your PHOTON BLAZE™.

4. Clean the plastic lens on the front side of your PHOTON BLAZE™ once per week, or as NEEDED, using a 3M Lens Cleaning Cloth, thus ENSURING that the SOLID DEEP RED Light Beam is being emitted at it's MAXIMUM Output.

5. Do NOT look DIRECTLY into or view DIRECTLY with Optical Instruments the colored Light Beam from your PHOTON BLAZE™ for MORE than 1-2 seconds, thus ENSURING that there will NOT be a Spot before your Eyes for 1 or MORE Hours!

6. Do NOT allow a Child to operate your PHOTON BLAZE™, unless he/she is SUPERVISED by an Adult!