PHOTON POINTER EXCEL™ - Operating Instructions

DISCLAIMER: Your PHOTON POINTER EXCEL™ is to be used "FOR EXPERIMENTAL PURPOSES ONLY".

Preliminary Comments:

1. Your PHOTON POINTER EXCEL™ can radiate a SOLID Red, Yellow or Green Light Beam, being powered by 1 - 3.6 Volt Rechargeable Ni-Cad Battery, which is inside it's Case/Handle. This SOLID Red, Yellow or Green Light Beam can then be shined onto a SPECIFIC Acupuncture Point, Trigger (center of pain) Point &/or Reflex Point or be used to "light paint" a LARGE affected Body Area (i.e. - Skin, Joints, Involved Muscles, Tumors, etc.).

2. Please follow these Steps CAREFULLY to ENSURE EFFICIENT Operation of and EFFICACIOUS Results from your PHOTON POINTER EXCEL™.

Operating Steps:

1. Push the Black Rubber Button on the front of the Case/Handle of your PHOTON POINTER EXCEL™ to turn the Light Beam "ON".

2a. Hold your PHOTON POINTER EXCEL™ like a Pen, gripping around the Case/Handle near the Head, when you want to shine the Red, Blue, Green or Yellow Light Beam DIRECTLY onto a SPECIFIC Acupuncture Point, Trigger (center of pain) Point, &/or Reflex Point at a Distance of NO MORE than 1/4" above the Skin or, BETTER yet, place the end of the tip of of your PHOTON POINTER EXCEL™ NEXT to the Skin and move the Head in a SLOW CLOCKWISE Circle, starting about 1" from the Acupuncture Point, Reflex Point or Trigger (center of pain) Point, moving towards the center and lastly holding the Head on this Point for 1-3 mins..
NOTE: If your Hand/Wrist gets TIRED, holding your PHOTON POINTER EXCEL™ in the "Pen" Position, curl your Fingers around the Case/Handle, while it's resting on the Base of the Palm of your Hand underneath. If your Hand is MORE COMFORTABLE in this NEW Handhold Position, you may want to use it indefinitely, instead of using the "Pen" Position.

2b. Unscrew Head on the Case/Handle of your PHOTON POINTER EXCEL™, when you want to "light paint" a LARGE (more than 1/2") affected Body Area (i.e. - Skin, Joints, Involved Muscles, Tumors, etc.) by tracing 1" CLOCKWISE Circles with the Red, Blue, Green or Yellow Light Beam. Continue to "light paint" the LARGE Area for 3-5 mins..
NOTE: The Rate, that you use, when you trace these Circles, can be varied from SLOW to VERY RAPID. CHRONIC Condtions usually respond BEST to a RAPID Rate, whereas ACUTE Condtions usually respond BEST to a SLOWER Rate.
Please see the SPECIFIC Biophoton Light Therapy Treatment Instructions for the Frequency & Duration Of Treatments.

MAJOR PAIN POINTS

MAJOR PAIN POINTS



< No. 2 - A quarter of a finger proximal and towards the thumb from the thumb side of the base of the nail of the index finger.

< No.1 - On the highest point of the hill formed when the straight thumb is pressed against the side of the index finger.

3. Perform this Procedure on each Point/Area, that NEEDS to be treated, for 1-3 minutes.
NOTE: This Procedure can be done up to 3 times per day, and each Point/Area should receive a MAXIMUM Treatment Time per Day of 3 mins. (acute conditions) and 5 mins. (chronic conditions).

4. When you're FINISHED using your PHOTON POINTER EXCEL™ in the SOLID/CONTINUOUS Red, Blue, Green or Yellow Light Beam Mode, push the Black Rubber Button again on the front of the Case/Handle of your PHOTON POINTER EXCEL™ to turn the Light Beam "OFF".
NOTE: The 1 Watt Luxeon LED in your PHOTON POINTER EXCEL™ draws 350 ma. of Current, and so you NEED to turn the Light Beam "OFF" to CONSERVE the Energy of the 3.6 Volt Rechargeable Ni-Cad Battery, which is inside it's Case/Handle.

Final Comments:

1. Continue your EXPERIMENTAL Biophoton Light Therapy Treatments until you've obtained the DESIRED Results.

2. DISCONTINUE &/or MODIFY the EXPERIMENTAL Light Treatment with your PHOTON POINTER EXCEL™, if DETOXIFICATION becomes TOO UNCOMFORTABLE, but then just as SOON as possible (1-2 days), please continue your EXPERIMENTAL Light Treatment.

3. Monitor the duration of the EXPERIMENTAL Biophoton Light Therapy Treatments, when you're using your PHOTON POINTER EXCEL™ with a Digital Timer (i.e. - Radio Shack No. 63-878 or 63-917).

4. Clean the Lens on the Head of your PHOTON POINTER EXCEL™ once per week, or as NEEDED, using a 3M Lens Cleaning Cloth, thus ENSURING that the Red, Blue, Green or Yellow Light Beam is being emitted at it's MAXIMUM Output.

5. ONLY use the 3.6 Volt Rechargeable Ni-Cad Battery, that has been included with your PHOTON POINTER EXCEL™, thus ENSURING that the Lifespan of the 1 Watt Luxeon LED isn't LIMITED and/or that the 1 Watt Luxeon LED isn't DAMAGED!

6. Recharge the 3.6 Volt Rechargeable Ni-Cad Battery for 2.5 Hours, using the Recharger Power Supply provided, if and when the 1 Watt Luxeon LED BURNS-OUT after about 6 Hours. Please be SURE to observe the Polarity (+) of the 3.6 Volt Rechargeable Ni-Cad Battery, when recharging it.

7. Please be SURE to observe the Polarity (+) of the 3.6 Volt Rechargeable Ni-Cad Battery, when recharging it.

8. Do NOT look DIRECTLY into or view DIRECTLY with Optical Instruments the Light Beam from your PHOTON POINTER EXCEL™ for MORE than 1-2 seconds, thus ENSURING that there will NOT be a Spot before your Eyes for 1 or MORE Hours!

9. Do NOT allow a Child to operate your PHOTON POINTER EXCEL™, unless he/she is SUPERVISED by an Adult!

Revised 12/20/05