PHOTON WAND II™ - Operating Instructions

DISCLAIMER: Your PHOTON WAND II™ is to be used "FOR EXPERIMENTAL PURPOSES ONLY".

By law, I must tell you that at NO time should the PHOTON WAND II™ be used to replace PROPER Medical Treatment, or be considered as a Replacement for PROPER Physician Care and for ALL Medical Conditions consult your Physician FIRST, before using this Experimental Biophoton Device, unless, of course, you are a physician.

NOTE: Please CLICK HERE to read information about the various actions, applications, effects and/or uses for the different LED Colors.

Preliminary Comments:

1. Your PHOTON WAND II™ can radiate a SOLID Red (or Yellow, Green or Blue) Light Beam, being powered by the 2 - 'AA' 1 1/2 Volt Alkaline Batteries, which are mounted inside of the Case of your PHOTON WAND II™. This SOLID Red (or Yellow, Green or Blue) Light Beam can then be shined onto a SPECIFIC Acupuncture Point, Trigger (center of pain) Point &/or Reflex Point or be used to "light paint" a LARGE affected Body Area (i.e. - Skin, Joints, Involved Muscles, Tumors, etc.).

2. Please follow these Steps CAREFULLY to ENSURE EFFICIENT Operation of and EFFICACIOUS Results from your PHOTON WAND II™.

Operating Steps:

1. Unscrew the rear cap on your PHOTON WAND II™ and insert both of the 'AA' Alkaline batteries, that are included, facing the positive (+) tip forward.

2. Push the black button on the head of your PHOTON WAND II™ to turn "ON" a SOLID Red (or Yellow, Green or Blue) Light Beam.

3a. Hold your PHOTON WAND II™ like a Pen and shine the Red (or Yellow, Green or Blue) Light Beam DIRECTLY onto a SPECIFIC Acupuncture Point, Trigger (center of pain) Point, &/or Reflex Point at a Distance of NO MORE than 1/4" above the Skin or, BETTER yet, place the end of the tip of of your PHOTON WAND II™ NEXT to the Skin and move the tip in a SLOW CLOCKWISE Circle, starting about 1" from the Acupuncture Point, Reflex Point or Trigger (center of pain) Point and moving towards the center and then holding the head in place there for 2-5 mins.

3b. Light paint" a LARGE (more than 1/4") affected Body Area (i.e. - Skin, Joints, Involved Muscles, Tumors, etc.) by tracing 1" CLOCKWISE Circles with the SOLID Red (or Yellow, Green or Blue) Light Beam.
NOTE: When you're tracing these Circles, the Rate can be varied from SLOW to VERY RAPID. CHRONIC Condtions usually respond BEST to a RAPID Rate, whereas ACUTE Condtions usually respond BEST to a SLOWER Rate.
Please see the SPECIFIC Biophoton Light Therapy Treatment Instructions for the Frequency & Duration Of Treatments.

MAJOR PAIN POINTS

MAJOR PAIN POINTS



< No. 2 - A quarter of a finger proximal and towards the thumb from the thumb side of the base of the nail of the index finger.

< No.1 - On the highest point of the hill formed when the straight thumb is pressed against the side of the index finger.

4. Perform this Procedure on each Point/Area, that NEEDS to be treated, for 2-5 minutes.
NOTE: This Procedure can be done up to 3 times per day, and each Point/Area should receive a MAXIMUM Treatment Time per Day of 10 mins. (acute conditions) and 15 mins. (chronic conditions).

5. When you're FINISHED using your PHOTON WAND II™ in the SOLID Red (or Yellow, Green or Blue) Light Beam Mode, please push the black button on the head of your PHOTON WAND II™ again to turn "OFF" the SOLID Red (or Yellow, Green or Blue) Light Beam.

Final Comments:

1. Continue your EXPERIMENTAL Biophoton Light Therapy Treatments until you've obtained the DESIRED Results.

2. DISCONTINUE &/or MODIFY the EXPERIMENTAL Light Treatment with your PHOTON WAND II™, if DETOXIFICATION becomes TOO UNCOMFORTABLE, but then just as SOON as possible (1-2 days), please continue your EXPERIMENTAL Biophoton Light Therapy Treatments.

3. Monitor the duration of the EXPERIMENTAL Biophoton Light Therapy Treatments, when you're using your PHOTON WAND II™, with a Digital Timer (i.e. - Radio Shack No. 63-248).

4. Clean the Plastic Lens at the front end of your PHOTON WAND II™ once per week, or as NEEDED, using a 3M Lens Cleaning Cloth, thus ENSURING that the SOLID Red (or Yellow, Green or Blue) Light Beam is being emitted at it's MAXIMUM Output.

5. Please REMOVE the end-cap, whenever the original 'AA' Alkaline Batteries have EXPIRED and replace them with FRESH 'AA' Alkaline Batteries only (NOT other types - NiMH, NiCad, Lithium or ...).

6. Do NOT look DIRECTLY into or view DIRECTLY with Optical Instruments the colored Light Beam from your PHOTON WAND II™ for MORE than 1-2 seconds, thus ENSURING that there will NOT be a Spot before your Eyes for 1 or MORE Hours!

7. Do NOT allow a Child to operate your PHOTON WAND II™, unless he/she is SUPERVISED by an Adult!

Revised 7/6/11