PHOTON TORCH XL™ - Pain Relief

NOTE: The following Information contains an Alternative Healing Method that has been found to be EFFECTIVE in HELPING the Body to RELIEVE Pain.

1. Push the right-angle RCA Plug, which is connected to one end of the 10 ft. Coiled Cable, that has a right-angle 1/8" Plug connected to the other end, into the RCA Jack, which is labeled "OUTPUT" on the Control Box.

2. Push the right-angle 1/8" Plug, which is connected to other end of the 10 ft. Coiled Cable, that has the right-angle RCA Plug now connected to the RCA "OUTPUT" Jack, into the 1/8" Jack, which is on the Black Cap at one end of Metal Wand/Case of your PHOTON TORCH XL™.

3. Clip the Control Box onto your Belt (or skirt edge).

4. Flip the minature Toggle Switch on the Control Box of your PHOTON TORCH XL™ to the "SOLID" Position, since your PHOTON TORCH XL™ is going to be operated in the SOLID/CONTINUOUS (sedation - pain & swelling) RED Light Beam Mode.
NOTE: A SOLID/CONTINUOUS RED Light Beam should NOW be shining from the tip of your PHOTON TORCH XL™, and if it is, then proceed to Step 5a or 5b. But if a SOLID/CONTINUOUS RED Light Beam is NOT shining from the tip of your PHOTON TORCH XL™, then please check your Cables and Connectors. If they are NOT the PROBLEM, then please contact me (Tom) at 614/237-2590 or tharrels@hotmail.com.

5a. Hold your PHOTON TORCH XL™ like a Pen and shine the SOLID/CONTINUOUS RED Light Beam about 1/4" above and about 1/2" from the MAJOR PAIN POINT No. 1 (see below) on the OPPOSITE Hand from the AREA of PAIN. Now circle the SOLID/CONTINUOUS RED Light Beam clockwise around, into and then place onto the MAJOR PAIN POINT No. 1 (see below).
NOTE: Do this EXPERIMENTAL Biophoton Light Therapy Treatment for 2-5 mins. - 2 times per day. If using MAJOR PAIN POINT No. 1 isn't EFFECTIVE, then place your PHOTON TORCH XL™ onto the MAJOR PAIN POINT No. 2 (see below).

MAJOR PAIN POINTS

MAJOR PAIN POINTS



< No. 2 - A quarter of a finger proximal and towards the thumb from the thumb side of the base of the nail of the index finger.

< No.1 - On the highest point of the hill formed when the straight thumb is pressed against the side of the index finger.

5b. And/or hold the PHOTON TORCH XL™ like a Pen and shine the SOLID/CONTINUOUS RED Light Beam about 1/4" above and about 1/2" from the the Trigger (pain) Point. Now circle the SOLID/CONTINUOUS RED Light Beam clockwise around, into and then place onto the Trigger (pain) Point).
NOTE: Do this EXPERIMENTAL Biophoton Light Therapy Treatment for 2-5 mins. - 2 times per day.

5c. And/or hold the PHOTON TORCH XL™ like a Pen and "paint" the Pain Area with the SOLID/CONTINUOUS RED Light Beam.
NOTE: Do this EXPERIMENTAL Biophoton Light Therapy Treatment for 5-10 mins. - 2-3 times per day.

6. Flip the minature Toggle Switch on the Control Box of your PHOTON TORCH XL™ to the PULSE/OFF Position, when you have COMPLETED your EXPERIMENTAL Biophoton Light Therapy Treatment.

7. Continue your EXPERIMENTAL Biophoton Light Therapy Treatments until the DESIRED Results have been achieved.
NOTE: If you keep a Log, while using this Protocol, please let me know about the progress of your Pain Problem(s).

Revised 1/30/10