The PHOTON TORCH IR™ is NOW AVAILABLE as a LOW-Cost alternative to the MORE COSTLY Biophoton Tools, which are AVAILABLE today! The PHOTON TORCH IR™ should be considered to be an Experimental Biomedical Device. The following applications should be considered as basic protocols to learn how this Biophoton Technology operates and be used "For Experimental Use ONLY". By law, I must tell you that at NO time should the PHOTON TORCH IR™ be used to replace PROPER Medical Treatment, or be considered as a replacement for PROPER Physician care and for ALL medical conditions, please consult your Physician FIRST, before using this Experimental Biophoton Tool. NOTE: Please see the PHOTON TORCH IR™ - Operating Instructions for BASIC Operation. Also, the following treatment instructions are general guidelines and can modified to suit your requirements. The ACTIVE lighted Area, being emitted by your PHOTON TORCH IR™, is about 1-2 inches in diameter. For General Use, this Area is IDEAL for treating LARGER Areas QUICKLY and more EFFECTIVELY. This makes the PHOTON TORCH IR™ IDEAL for EASY Applications on Acupuncture, Acupressure and Reflex Points. The LARGE Area of Light Energy makes it ideal for Pain Management, when SPECIFC Areas need MORE INTENSE Stimulation, this is EXTREMELY USEFUL for CHRONIC Pain Conditions, Dental Pain and Skin Conditions such as Acne, Burns, Insect Bites and Cold Sores. Place the head of the PHOTON TORCH IR™ against or near (1/4-1/2 inch) and shine the Red light beam on the Skin at the designated Acupoints, that are being treated, for a period of 2-3 minutes. If dealing with pain, swelling and/or inflammation, place the head of the PHOTON TORCH IR™ against the skin in the center of the painful area for 3-5 minutes. Next, select 3 or 4 points around the painful or swollen area and repeat the process for an additional 2 Minutes for each point. REPEAT this treatment session as NEEDED. Place the head of the PHOTON TORCH IR™ against the skin just over the center of the dental pain. Hold the PHOTON TORCH IR™ in this position for 5-10 Minutes. Next, select Points on both sides of the center of the painful area(s) and treat these points for ONLY 2 minutes each and then REPEAT, if necessary. Shine the INFRARED (850nm - invisible) light beam about 1/4 inch above the area of the skin to be treated. Move the PHOTON TORCH IR™ VERY SLOWLY back and forth, light painting the Area, that is being treated, for 3-5 minutes. Repeat 3 times a day or do 1 - 10-15 minute treatment session.
NOTE: These 2 - MAJOR Pain Points are an EXCELLENT Acupoints to use for pain, that is occuring anywhere in the body.