NOTE: Also please see and read the enclosed factory User's Manual (pages 23-30) and Frequency Manual, plus the WAVESHAPER™ Frequency Instrument - User's Guide, and the SPECIFIC Accessory Operating Instructions, that you are operating (i.e. - BIOENERGY AMPLIFIER™, ELECTRO-CELLULAR ENERGIZER I™, ELECTRO-CELLULAR ENERGIZER II™, BIOMAGNESONIC TRANSDUCER II™, BIOMAGNESONIC TRANSDUCER XL™ or PHOTON TORCH XL™). 1. Plug the A.C. Plug, which is connected to the A.C. Power Cable, that comes with your WAVESHAPER™ Frequency Instrument, into a HIGH Quality Surge Suppressor Power Strip (i.e.- Tripp Lite Isobar 4 Ultra, 6 Ultra or 8 Ultra), thus ensuring SAFE and EFFICIENT Operation. 2. Push the 3-pin Power Jack, which is connected to the other end of this A.C. Power Cable, into the 3-pin Power Plug, that's mounted on the Rear Panel of your WAVESHAPER™ Frequency Instrument. 3. Connect the Accessory, that you want to operate (i.e. - BIOENERGY AMPLIFIER™, ELECTRO-CELLULAR ENERGIZER I™, BIOMAGNESONIC TRANSDUCER II™, BIOMAGNESONIC TRANSDUCER XL™, BIOPHOTON CLUSTER™, BIOPHOTON WAND™ or PHOTON TORCH XL™), using your WAVESHAPER™ Frequency Instrument, to one (see Accessory Operating Instructions) of the 2 - BNC Jacks (front panel - lower right side), that are labeled TTL/CMOS OUTPUT and OUTPUT 50 ohms. 4. Push the POWER Button (lower left corner) on your WAVESHAPER™ Frequency Instrument 'IN' once to turn it's Power "ON". 5. Press the WAVE Button (upper right corner - display) until the Waveform (square, sine or triangle/sawtooth), that you're needing, appears on the LED Display. 6. Press the VALID Buttons in sequence on the Touchpad for the SPECIFIC Frequency, that you're needing, and right afterwards press either the kHz. or Hz. Button as required. 7. Press the SHIFT Button and then right afterwards press the DUTY (7) Button, until the DUTY LED appears. 8. Press the VALID Buttons for the Duty Cycle required (i.e. - 80%: PHOTON TORCH XL™) on the Touchpad, which is the MAXIMUM Seting in sequence and then right afterwards press the Hz./% Button. 9. Push the POWER Button (lower left corner) on your WAVESHAPER™ Frequency Instrument 'IN' again to turn it's Power "OFF", when your Treatment Session has been COMPLETED. NOTE: Monitor your Experimental Treatment Time of ANY Accessory for each SPECIFIC Frequency with a Digital Timer (i.e. - Radio Shack No. 63-878).
NOTE: Please notice that TTL also appears, whenever the Square Waveform (stairstep) is selected.
NOTE: The large Knob (upper right corner) can also be turned either clockwise (up) or counter-clockwise (down) and/or the Arrow Buttons can be pressed either left (down) or right (up) to change the Frequency in increments.